Snom PA-1 Paging Box

Important: The Snom PA-1 MUST be upgraded to firmware version 8.7.5.75. You can do that by going here: https://service.snom.com/display/wiki/FW+v8.7.5.75+MRU+PA1 and updating it manually.

Step 1: Log into the device

Step 2: Click the "Advanced" section on the left navigation area.

Step 3: Go to the "Update" tab.

Step 4: Set "Update Policy" to Automatic.

Step 5: Set the Setting URL to the address in the PBX Provisioning GUI for SNOM devices.

Step 6: Set "PnP Config" to Off.

Step 7: Click "Apply" below.

Step 8: Make sure to Save Changes before you Reboot.