Cisco ATA
(The following screenshots apply to both provisioning articles below.)
You will need the following information to complete the steps below:
A. The Provisioning URL. From the PBX Admin Portal, navigate to Extensions > Provisioning.
How do I provision a Cisco SPA122 ATA?
STEPS
1. Plug the SPA122 into a power source, and plug an Ethernet Cable from your router/switch to the Ethernet Port on the ATA.
2. Manually change your computer's IP address to 192.168.15.2 (Subnet 255.255.255.0, no gateway).
- How you do this will depend on your operating system.
3. Launch your internet browser (Google Chrome is preferred) and go to 192.168.15.1.
4. When prompted enter the default login/password of admin / admin.
Note: The PrimeVOX System changes the default password to admin123
5. Navigate to the Voice > Provisioning.
- Replace the entire Profile Rule with the Provisioning URL ((item A above).
- Set the Transport Protocol to HTTP .
6. Click Submit, and wait 40 seconds.
7. Navigate to the Network Setup tab and set Network to Bridge Mode.
8. Click Submit:
- While the device boots, switch the Ethernet Cable to the Internet Port on the ATA.
- Wait about 5 minutes. If the power light is still blinking, reboot the ATA manually by pulling the power plug.
- Wait another 5 minutes. The ATA should be provisioned at this point. If it is still not provisioned, contact Technical Support.
IMPORTANT NOTE: When done, be sure to set computer's IP address back to normal.
How do I provision a Cisco SPA112 / SPA8000 ATA?
STEPS
1. Plug the ATA into a power source and into the network.
2. Locate your devices's IP address by using an IP Scanner that allows you to search by MAC on your network.
3. Launch your internet browser (Google Chrome is preferred) and enter that IP address.
4. When prompted enter the default login/password of admin / admin.
5. Navigate to the Voice > Provisioning.
- Replace the entire Profile Rule with the Provisioning URL ((item A above).
- Set the protocol to HTTP .
6. Click Submit, and wait 40 seconds.
- Wait about 5 minutes. If the power light is still blinking, reboot the ATA manually by pulling the power plug.
- Wait another 5 minutes. The ATA should be provisioned at this point. If it is still not provisioned, contact Technical Support.
Related Articles
Grandstream ATA
A note about the Grandstream HT81x Series ATAs: The MAC Address you use in our provisioning GUI must be the LAN or "Local Device" MAC Address. The WAN address that comes up on an IP Scanner will not work for provisioning. The LAN or "Local Device" ...Cisco Phone
A common practice when troubleshooting and provisioning IP devices is the factory reset, or a full restoration of the phone to its factory settings. It is important to understand that while factory resetting a phone is a great backup plan if a device ...Cisco Phone
How do I provision my Cisco phones? Applies to Models SPA30x / SPA5xxx NOTE: If the phone you are about to provision was previously purchased from or provisioned by another service provider, please reset your phone before proceeding with the ...Diagnosing Faxing Issues
If you're using a traditional fax machine, the fax line coming out of the fax machine will more than likely be connected to a Fax ATA. A Fax ATA converts an analog fax signal into a digital fax signal that can travel over the internet. The most ...Grandstream HT812 Quick Start Guide
Getting Started Setting up a Grandstream HT812 ATA (Analog Telephone Adaptor). Connect the power cord the port labeled “DC 12V”. Connect an internet source to the ethernet port with the “Globe” Icon. Connect an analog phone line from the fax machine ...