Manually Provisioning Cisco Phones

Overview

Applies to Models SPA30x / SPA5xxx

You will need the following information to complete the steps below:

A. The IP address of the Cisco phone. On the phone, press the Setup button (), navigate to Settings > Network Configuration. Scroll to view the current IP address; and

B. The Provisioning URL. From the PBX Admin Portal, navigate to Extensions → Provisioning.

NOTE: If the phone you are about to provision was previously purchased from or provisioned by another service provider, please reset your phone before proceeding with the following steps.

How do I provision my Cisco phones?

1. Launch your internet browser (Google Chrome is preferred).

2. Enter the IP address (item A above) of the Cisco phone into your browser.

3. When prompted enter the default login/password of admin / admin.

4. Select the Voice tab.
Set the entire Profile Rule with the Provisioning URL (item B above).
Set the protocol to HTTP.
5. Click Submit, then wait 40 seconds.

6. Reboot the phone.

Wait approximately 5 minutes. If the phone is not provisioned, reboot it again.