Manually Provisioning a Snom PA-1 Paging Box

Manually Provisioning a Snom PA-1 Paging Box

Important Firmware Requirement


Before provisioning, the Snom PA-1 must be upgraded to firmware version 8.7.5.75. You can download and install the firmware manually using the following link: 
​

 

Provisioning Steps


1. Log in to the device.

2. Click the "Advanced" section on the left navigation area.

3. Go to the "Update" tab.

4. Set "Update Policy" to "Automatic".

5. Set the Setting URL to the address in the PBX Provisioning GUI for SNOM devices.

6. Set "PnP Config" to "Off".
​
7. Click "Apply" below.

8. Make sure to Save Changes before you Reboot.
​
​
​

    • Related Articles

    • Manually Provisioning a Cisco ATA

      Overview You will need the following information to complete the steps below: The Provisioning URL. From the PBX Admin Portal, navigate to Extensions → Provisioning. (The following screenshots apply to both provisioning articles below.) How Do I ...

    • Manually Provisioning Cisco Phones

      Overview Applies to Models SPA30x / SPA5xxx You will need the following information to complete the steps below: A. The IP address of the Cisco phone. On the phone, press the Setup button (), navigate to Settings > Network Configuration. Scroll to ...

    • Manually Provisioning a Yealink Phone

      Overview NOTE: If the phone you are about to provision was previously purchased from or provisioned by another service provider, please reset your phone before proceeding with the following steps. You will need the following information to complete ...

    • Manually Provisioning a Grandstream Phone

      Overview Provisioning a Grandstream phone connects it to your phone system so it can make and receive calls using the correct settings. This guide will walk you through the basic steps to get your Grandstream device up and running, whether you're ...

    • Manually Provisioning a Grandstream ATA

      Overview When provisioning a Grandstream HT81x Series ATA, it’s important to ensure you’re using the correct MAC address and configuration steps. This guide covers how to locate the correct IP and MAC addresses and how to configure the device for ...