Important: The Snom PA-1 MUST be upgraded to firmware version 8.7.5.75. You can do that by going here: https://service.snom.com/display/wiki/FW+v8.7.5.75+MRU+PA1 and updating it manually.
Step 1: Log into the device
Step 2: Click the "Advanced" section on the left navigation area.
Step 3: Go to the "Update" tab.
Step 4: Set "Update Policy" to Automatic.
Step 5: Set the Setting URL to the address in the PBX Provisioning GUI for SNOM devices.
Step 6: Set "PnP Config" to Off.
Step 7: Click "Apply" below.
Step 8: Make sure to Save Changes before you Reboot.
Related Articles
Snom M700 Provisioning
Before provisioning your Snom M700 base station, please upgrade its firmware to the following versions (or higher): Base 510 Branch 1 To Do: Add steps for provisioning the device.
Page Groups
What is a Page Group? Page Groups allow you to broadcast one-way or two-way audio messages to multiple devices simultaneously. They are commonly used for in-office announcements, department-wide paging, or emergency alerts. Example: A receptionist ...
UCP Access
This is the UCP Box selection screen. You have the ability to give users access to 1 or more UCP boxes on 1 or more containers. Creating a UCP Box Go into the Phone System Administration area, and select the container in which you want to build a new ...
Star Codes
What are Star Codes? Star codes are shortcuts for enabling and/or utilizing certain features of your phone system without use of programmable buttons or searching through menu options. Voicemail Codes *97 - Voicemail Access: Though most desk phones ...
Purchasing and Managing Phone Numbers
Introduction Higher-level users have the ability to purchase phone numbers directly from the platform. Purchasing phone numbers allows you to assign local, toll-free, or international numbers to your account(s) for use with extensions, call flows, or ...