Other Devices
3CX SIP Trunking
Configuring a SIP Trunk in 3CX for Primevox Step 1: Create a new SIP Trunk in 3CX by going to SIP Trunks → Add SIP Trunk. Country: Generic Provider: Generic SIP Trunk Main Trunk Number: (a DID you might have with us) Step 2 (General Tab): Registrar: ...
Manually Provisioning a ReadyNet LTE520
ReadyNet LTE520 Settings Minimum Firmware Version: v3.32 - Released in 2020 SIP Transport: TCP (UDP will NOT function!) Signal Port: 4242 Register Refresh Interval: 600 Outbound Server: Use any of the "New Generation, No Redundancy" A-Records in ...
Manually Provisioning a Snom PA-1 Paging Box
Important Firmware Requirement Before provisioning, the Snom PA-1 must be upgraded to firmware version 8.7.5.75. You can download and install the firmware manually using the following link: https://service.snom.com/display/wiki/FW+v8.7.5.75+MRU+PA1 ...
Manually Provisioning a Cisco ATA
Overview You will need the following information to complete the steps below: The Provisioning URL. From the PBX Admin Portal, navigate to Extensions → Provisioning. (The following screenshots apply to both provisioning articles below.) How Do I ...
Factory Resetting a Cisco Phone
Overview A common practice when troubleshooting and provisioning IP devices is the factory reset, or a full restoration of the phone to its factory settings. It is important to understand that while factory resetting a phone is a great backup plan if ...
Manually Provisioning Cisco Phones
Overview Applies to Models SPA30x / SPA5xxx You will need the following information to complete the steps below: A. The IP address of the Cisco phone. On the phone, press the Setup button (), navigate to Settings > Network Configuration. Scroll to ...
Manually Provisioning a Fanvil IP Phone
Setting Up Your Fanvil Phone 1. Make sure your Fanvil phone is in a factory reset state. You can do this through the phone's GUI or through its web portal interface. 2. Log into the phone's web portal interface. Default username/password is ...